Titanium(IV) 2-Ethylhexanoate

CAS #:

Linear Formula:

(C8H15O2)4Ti

MDL Number:

MFCD05663781

EC No.:

N/A

ORDER

PRODUCT Product Code ORDER SAFETY DATA TECHNICAL DATA
≥96% Titanium(IV) 2-Ethylhexanoate
TI4-2EH-01-LIQ
Pricing > SDS > Data Sheet >

Titanium(IV) 2-Ethylhexanoate Properties (Theoretical)

Compound Formula C32H60O8Ti
Molecular Weight 620.691
Appearance Liquid
Melting Point N/A
Boiling Point 228 °C
Density N/A
Solubility in H2O Immiscible
Exact Mass 620.377 g/mol
Monoisotopic Mass 620.377 g/mol

Titanium(IV) 2-Ethylhexanoate Health & Safety Information

Signal Word Warning
Hazard Statements H361
Hazard Codes Xn
Precautionary Statements P280
Risk Codes N/A
Safety Statements N/A
Transport Information NONH for all modes of transport
GHS Pictograms

View and Print SDS

SAFETY DATA SHEET

Date Accessed: 11/19/2024
Date Revised:01/15/2022

SECTION 1. IDENTIFICATION

Product Name: Titanium(IV) 2-Ethylhexanoate

Product Number: All applicable American Elements product codes, e.g. TI4-2EH-01-LIQ

CAS #: 3645-34-9

Relevant identified uses of the substance: Scientific research and development

Supplier details:
American Elements
10884 Weyburn Ave.
Los Angeles, CA 90024
Tel: +1 310-208-0551
Fax: +1 310-208-0351

Emergency telephone number:
Domestic, North America: +1 800-424-9300
International: +1 703-527-3887


SECTION 2. HAZARDS IDENTIFICATION

Classification
This chemical is considered hazardous by the 2012 OSHA Hazard Communication Standard (29 CFR 1910.1200)
Label Elements

Health Hazard - GHS08

Signal Word
Warning
Hazard Statements
Suspected of damaging the unborn child
Precautionary Statements
Prevention
Obtain special instructions before use
Do not handle until all safety precautions have been read and understood
Use personal protective equipment as required
Response
IF exposed or concerned: Get medical attention/advice
Storage
Store locked up
Disposal
Dispose of contents/container to an approved waste disposal plant
Hazards not otherwise classified (HNOC)
None identified


SECTION 3. COMPOSITION/INFORMATION ON INGREDIENTS

Hexanoic acid, 2-ethyl-, titanium(4+) salt
3645-34-9


SECTION 4. FIRST AID MEASURES

General Advice If symptoms persist, call a physician.
Eye Contact Rinse immediately with plenty of water, also under the eyelids, for at least 15 minutes. Get medical attention.
Skin Contact Wash off immediately with plenty of water for at least 15 minutes. If skin irritation persists, call a physician.
Inhalation Remove to fresh air. If not breathing, give artificial respiration. Get medical attention if
symptoms occur.
Ingestion Clean mouth with water and drink afterwards plenty of water.
Most important symptoms and effects
None reasonably foreseeable.
Notes to Physician Treat symptomatically


SECTION 5. FIREFIGHTING MEASURES

Suitable Extinguishing Media Carbon dioxide (CO 2). Powder. Water spray. In case of major fire and large quantities:
Evacuate area. Fight fire remotely due to the risk of explosion.
Unsuitable Extinguishing Media No information available
Flash Point No information available
Method - No information available
Autoignition Temperature No information available
Explosion Limits
Upper No data available
Lower No data available
Sensitivity to Mechanical Impact No information available
Sensitivity to Static Discharge No information available
Specific Hazards Arising from the Chemical
Keep product and empty container away from heat and sources of ignition.
Hazardous Combustion Products
Carbon monoxide (CO). Carbon dioxide (CO2). Titanium oxides.
Protective Equipment and Precautions for Firefighters
As in any fire, wear self-contained breathing apparatus pressure-demand, MSHA/NIOSH (approved or equivalent) and full protective gear.
NFPA
Health: 0
Flammability: 1
Instability: 0
Physical hazards: -


SECTION 6. ACCIDENTAL RELEASE MEASURES

Personal Precautions Ensure adequate ventilation. Use personal protective equipment as required.
Environmental Precautions Should not be released into the environment. See Section 12 for additional Ecological Information. Do not allow material to contaminate ground water system. Do not flush into surface water or sanitary sewer system.
Methods for Containment and Clean Up
Soak up with inert absorbent material. Keep in suitable, closed containers for disposal.


SECTION 7. HANDLING AND STORAGE

Handling Wear personal protective equipment/face protection. Ensure adequate ventilation. Avoid
ingestion and inhalation. Do not get in eyes, on skin, or on clothing.
Storage Keep containers tightly closed in a dry, cool and well-ventilated place.


SECTION 8. EXPOSURE CONTROLS/PERSONAL PROTECTION

Exposure Guidelines This product does not contain any hazardous materials with occupational exposure limits established by the region specific regulatory bodies.
Engineering Measures None under normal use conditions.
Personal Protective Equipment
Eye/face Protection Wear appropriate protective eyeglasses or chemical safety goggles as described by OSHA's eye and face protection regulations in 29 CFR 1910.133 or European Standard EN166.
Skin and body protection Wear appropriate protective gloves and clothing to prevent skin exposure.
Respiratory Protection No protective equipment is needed under normal use conditions.
Hygiene Measures
Handle in accordance with good industrial hygiene and safety practice.


SECTION 9. PHYSICAL AND CHEMICAL PROPERTIES

Physical State Liquid
Appearance No information available
Odor Odorless
Odor Threshold No information available
pH No information available
Melting Point/Range No data available
Boiling Point/Range No information available
Flash Point No information available
Evaporation Rate No information available
Flammability (solid,gas) Not applicable
Flammability or explosive limits
Upper No data available
Lower No data available
Vapor Pressure No information available
Vapor Density No information available
Specific Gravity No information available
Solubility No information available
Partition coefficient; n-octanol/water No data available
Autoignition Temperature No information available
Decomposition Temperature No information available
Viscosity No information available
Molecular Formula C32 H60 O8 Ti
Molecular Weight 623.75


SECTION 10. STABILITY AND REACTIVITY

Reactive Hazard None known, based on information available
Stability Stable under normal conditions.
Conditions to Avoid Incompatible products.
Incompatible Materials Oxidizing agent
Hazardous Decomposition ProductsCarbon monoxide (CO), Carbon dioxide (CO2), Titanium oxides
Hazardous Polymerization Hazardous polymerization does not occur.
Hazardous Reactions None under normal processing.


SECTION 11. TOXICOLOGICAL INFORMATION

Acute Toxicity
Product Information
Component Information
Toxicologically Synergistic
Products
No information available
Delayed and immediate effects as well as chronic effects from short and long-term exposure
Irritation No information available
Sensitization No information available
Reproductive Effects No information available.
Developmental Effects No information available.
Teratogenicity No information available.
STOT - single exposure None known
STOT - repeated exposure None known
Aspiration hazard No information available
Symptoms / effects,both acute and delayed
No information available
Endocrine Disruptor Information No information available
Other Adverse Effects The toxicological properties have not been fully investigated.


SECTION 12. ECOLOGICAL INFORMATION

Ecotoxicity
May cause long-term adverse effects in the environment. Do not allow material to contaminate ground water system.
Persistence and Degradability Immiscible with water May persist
Bioaccumulation/ Accumulation No information available.
Mobility Is not likely mobile in the environment due its low water solubility.


SECTION 13. DISPOSAL CONSIDERATIONS

Waste Disposal Methods Chemical waste generators must determine whether a discarded chemical is classified as a hazardous waste. Chemical waste generators must also consult local, regional, and national hazardous waste regulations to ensure complete and accurate classification.


SECTION 14. TRANSPORT INFORMATION

DOT Not regulated
TDG Not regulated
IATA Not regulated
IMDG/IMO Not regulated


SECTION 15. REGULATORY INFORMATION

TSCA 12(b) - Notices of Export Not applicable
U.S. Federal Regulations
SARA 313 Not applicable
SARA 311/312 Hazard Categories See section 2 for more information
CWA (Clean Water Act) Not applicable
Clean Air Act Not applicable
OSHA - Occupational Safety and
Health Administration
Not applicable
CERCLA Not applicable
California Proposition 65 This product does not contain any Proposition 65 chemicals.
U.S. State Right-to-Know
Regulations
Not applicable
U.S. Department of Transportation
Reportable Quantity (RQ): N
DOT Marine Pollutant N
DOT Severe Marine Pollutant N
U.S. Department of Homeland Security
This product does not contain any DHS chemicals.
Other International Regulations
Mexico - Grade No information available


SECTION 16. OTHER INFORMATION

Safety Data Sheet according to Regulation (EC) No. 1907/2006 (REACH). The above information is believed to be correct but does not purport to be all inclusive and shall be used only as a guide. The information in this document is based on the present state of our knowledge and is applicable to the product with regard to appropriate safety precautions. It does not represent any guarantee of the properties of the product. American Elements shall not be held liable for any damage resulting from handling or from contact with the above product. See reverse side of invoice or packing slip for additional terms and conditions of sale. COPYRIGHT 1997-2022 AMERICAN ELEMENTS. LICENSED GRANTED TO MAKE UNLIMITED PAPER COPIES FOR INTERNAL USE ONLY.

About Titanium(IV) 2-Ethylhexanoate

Titanium(IV) 2-Ethylhexanoate is one of numerous organometallic compounds manufactured by American Elements under the trade name AE Organometallics™. Ethylhexanoates are carboxylates with many commercial applications. Titanium(IV) 2-Ethylhexanoate is commonly used as polymerization catalyst and as an adhesion promoter inKevla-phenolic composites. American Elements supplies organometallic compounds in most volumes including bulk quantities and also can produce materials to customer specifications. Please request a quote above for more information on pricing and lead time.

Titanium(IV) 2-Ethylhexanoate Synonyms

Tetrakis(2-ethylhexanoic acid) titanium(IV) salt, titanium(4+) octanoate, tetraoctanoic acid titanium(IV) salt, hexanoic acid, 2-ethyl-, titanium(4+) salt

Chemical Identifiers

Linear Formula (C8H15O2)4Ti
MDL Number MFCD05663781
EC No. N/A
Pubchem CID 6451578
IUPAC Name 2-ethylhexanoate; titanium(4+)
SMILES CCCCC(CC)C(=O)[O-].CCCCC(CC)C(=O)[O-].CCCCC(CC)C(=O)[O-].CCCCC(CC)C(=O)[O-].[Ti+4]
InchI Identifier InChI=1S/4C8H16O2.Ti/c4*1-3-5-6-7(4-2)8(9)10;/h4*7H,3-6H2,1-2H3,(H,9,10);/q;;;;+4/p-4
InchI Key GDKAXSGMPFSRJY-UHFFFAOYSA-J

Packaging Specifications

Typical bulk packaging includes palletized plastic 5 gallon/25 kg. pails, fiber and steel drums to 1 ton super sacks in full container (FCL) or truck load (T/L) quantities. Research and sample quantities and hygroscopic, oxidizing or other air sensitive materials may be packaged under argon or vacuum. Shipping documentation includes a Certificate of Analysis and Safety Data Sheet (SDS). Solutions are packaged in polypropylene, plastic or glass jars up to palletized 440 gallon liquid totes, and 36,000 lb. tanker trucks.

Related Elements

Titanium

See more Titanium products. Titanium (atomic symbol: Ti, atomic number: 22) is a Block D, Group 4, Period 4 element with an atomic weight of 47.867. The number of electrons in each of Titanium's shells is [2, 8, 10, 2] and its electron configuration is [Ar] 3d2 4s2. Titanium Bohr ModelThe titanium atom has a radius of 147 pm and a Van der Waals radius of 187 pm. Titanium was discovered by William Gregor in 1791 and first isolated by Jöns Jakob Berzelius in 1825. In its elemental form, titanium has a silvery grey-white metallic appearance. Titanium's properties are chemically and physically similar to zirconium, both of which have the same number of valence electrons and are in the same group in the periodic table. Elemental TitaniumTitanium has five naturally occurring isotopes: 46Ti through 50Ti, with 48Ti being the most abundant (73.8%). Titanium is found in igneous rocks and the sediments derived from them. It is named after the word Titanos, which is Greek for Titans.

TODAY'S TOP DISCOVERY!

November 19, 2024
Los Angeles, CA
Each business day American Elements' scientists & engineers post their choice for the most exciting materials science news of the day
CityUHK researchers discover method to reduce energy loss in metal nanostructures by altering their geometrical dimensions

CityUHK researchers discover method to reduce energy loss in metal nanostructures by altering their geometrical dimensions